Wireless Voice Communications and Remote Entrance
Unlocking Without the Huge Installation Expense
Longest-Range Outdoor
Wireless Intercom Provides Two-way Communication Anywhere You Need It!
The RoveTec
MURS Multi-Mile Long-Range Wireless Outdoor Intercom solves communication problems at locked entrances, remote gates,
or anywhere two-way communication is needed, but running wires is too
expensive or difficult. It not only enables voice communication, but you
can also use its built-in switch to unlock a door or gate that has an
electronic opener. To talk to the intercom, you can use handheld two-way
radios or base station intercoms.
The Multi-Mile Wireless is the longest range outdoor
wireless intercom available!
With most wireless communication devices, range is measured in
feet. With the Multi-Mile Wireless intercom you can reach
distances measured in miles depending on conditions.
You can adjust range by changing between its
one-watt or two-watt setting. Use the one-watt setting for shorter
distances. To achieve maximum range, mount
the included externally-mounted antenna mounted as high as possible.
The audio surveillance capability of this system enables you to listen in to the area around it if you notice someone
displaying suspicious behavior. Sending a two-tone signal from your monitoring
radio activates the intercom's Monitor feature, which puts the unit in
transmit mode for 15 seconds. You can then listen to activity around the
intercom. This feature can be used simultaneously with the gate opening
ability so you can listen in as a visitor enters.
The MURS Multi-Mile Wireless intercom operates on one of five channels
in the unlicensed MURS service. MURS is short for Multi-Use Radio
Service and was set up in the United States in the VHF (Very High
Frequency) two-way radio spectrum. No license is required to use MURS
frequencies so you won't have to go through the hassle and expense of
licensing.
An internal switch can be used to
activate a door or gate controller, switch on a light, sound an alarm,
or for any application where remote control of an on/off switch is
needed. Use this remotely activated feature to save unwanted trips,
reduce labor expense, provide extra security, increase customer service,
or for any other labor or cost saving application.
The intercom's metal housing and stainless steel
front, along with its waterproof internal housing make it both vandal and
weather resistant. Its attractive design fits in well in locations such
as residential gates, office building main entrances, or any application
that requires a durable yet unobtrusive appearance .
Intercom power comes from a 9-13 Volt DC,
1-amp or more source. This power could come from an optional AC to DC adapter, 12-volts from a gate opener,
or a solar-power system. This flexibility enables you to use
existing sources of power from any source that meets requirements. Power
supply is not provided.
Mounting and setting up the intercom is extremely
simple. The back of the intercom has mounting holes for wall or
gooseneck pole mounting. Plus, to maintain an attractive installation,
there is a cable routing hole so you can route the antenna cable, switch
control wires, and power supply wires. Changing settings on the intercom is done through switches or though a simple, menu-driven LCD display .
Use this outdoor wireless intercom for security
gates, delivery doors, loading docks, golf course order system, office
entry system, boat docks, parking lot security, construction elevators,
truck scales, OSHA compliance, storage facilities, areas of refuge, campgrounds, school playgrounds,
etc. With the intercom's long range and variety of power options, how
you use it is only limited by your imagination.
Notes:
A power supply is
not included with this outdoor intercom. If it is powered from an existing
gate operator or solar power system you do not need one. Otherwise
please order the OPTIONAL "Multi-Mile Outdoor Intercom Power Supply"
from Related Products and Accessories to the right.
You will need two-conductor
wire between the power supply and whatever power source you use.
Any low-voltage underground landscape lighting cable available
from building supply stores can be used.
The RoveTec MURS Multi-Mile
Long-Range Wireless Outdoor Intercom includes the following
components:
Click here for the user guide:
Long-Range Outdoor Wireless Intercom User Guide
Click here for
tips on how to install this intercom:
Installation Ideas
If you want to mount the antenna on the bottom of the metal
housing click here:
Antenna Installation
VIDEO
Features Simple push-to-talk operation, two-way voice communication to remote radio or base station Range: Has been tested up to 2 miles clear line of sight using the low power setting. To learn more about how far this intercom can communicate, go here: www.intercomsonline.com/range Installs and sets up in minutes An external 9-12 volt, 1 amp, DC power source is required. Easy, menu-driven LCD display feature changes Tamper resistant enclosure with stainless steel face plate, measures 7 5/16" H x 6 3/4" W x 4 5/8" D (4 5/8" depth at top; 3 5/8" at bottom) Weather-resistant housing Audio surveillance feature decodes a 2-Tone signal which activates the transmitter for 15 seconds so you can listen to area around the intercom Relay can be used to activate a gate controller, switch on a light, sound an alarm or any other application where remote control of an ON/OFF switch is required For internal switch use, confirm that your application will NOT exceed the maximum rating of the on-board relay of 120 VAC @ 1 amp Standard 2-tone decode for activation of relay Two modes of relay operation, Momentary and Toggle Relay closure timing: 1 to 255 seconds Internal rotating volume control adjustment Fully expandable to an unlimited number of stations. Add additional intercoms to your system as needs change Antenna and antenna mounting bracket are included One-meter antenna cable connected to the antenna. Additional cable lengths can be added (cable loss will start to occur over 20 feet) SMA-Female connector on callbox for an external antenna Provided external antenna has an SMA-Male connector Intercom mounts using standard 5/16” lag bolts or regular bolts Gooseneck hole mounting pattern on back (gooseneck pole not provided) Call tone sent on call initiation Intercom can be set for one of five channels Frequencies used: Channel 1: 151.820MHz; Channel 2: 151.880MHz; Channel 3: 151.940MHz; Channel 4: 154.570MHz; Channel 5: 154.600MHz Transmitter power adjustable between 1 and 2 watts 38 CTCSS interference eliminator codes (Continuous Tone Coded Squelch System) Squelch setting adjusts the threshold at which signals will open (un-mute) the audio channel Wireless Intercom can be powered from any 9-12 Volt DC power source that supplies a minimum of 1 amp of current Optional external 12 Volt DC transformer (requires 110 VAC available at the installation location) Programmable Automatic Turn-off feature to conserve solar panel battery life (callbox cannot receive calls in Automatic Turnoff Mode unless someone presses its button first) When used with transformer power the call box can be set so callbox can always receive calls Low battery alert tone is transmitted if solar power battery voltage drops below an acceptable level Works with 12 VDC door or gate operator systems Current draw: Auto Turn Off mode - 19mA, receiving a call - 100mA, transmitting: 566 mA 1-watt transmit, 742 mA 2-watt transmit No FCC license required for operation Reliable integrated RF design Temperature Operation: -30C to +50C 1 year RoveTec warranty
Related Products and Accessories
Long range, durable, yet attractive 
