| The Wirefree Alert &
Intercom can be used to
monitor any location where you want to be notified when people (or large
animals) are present. The waterproof, wireless motion Sensor detects
when someone is present and then alerts the inside intercom Base
unit.
The outdoor motion sensor alerts the inside, base
intercom unit with a tone and then and turns on its speaker for 10
seconds so you can hear what's happening at the sensor location.
If you wish to talk with a person at the sensor, hold down the TALK
button, speak, and then release to hear.
Up to eight motion sensors can be used with one internal base
station, They operate up to 1000 feet from the base.
If there is an accessory device (like a gate opener, camera, or
yard light) connected to a relay on the sensor unit, it can be
activated by pressing a "Remote" button within 30 seconds of the
alert signal.
The relay on the Sensor unit is a switch that can handle up to
120 volts at 10 amps. Accessory devices need their own power supply,
since the relay is just a switch and has no power of its own. The
relay will only activate when the Remote button on the base unit is
pressed. If you wish, you can flush mount the Sensor unit so that
access to the relay connections is prevented.
The Base unit also has the same relay that automatically closes
when the alarm buzzer sounds and can be used to activate louder
alarm bells, lights, cameras, or other accessories.
The Base unit can run on either batteries or the included power
transformer. The batteries also act as backup power in a power
outage. The Base for the WireFree Alert & Intercom are not
compatible with the WireFree Portable, Flush-mount, or Outdoor Intercoms. The
WireFree Intercom system can not communicate with the WireFree Alert sensor. |
