2 line phone and PA Speaker

Intercom with IP Horn Speaker

Write a Review

Your Price: $1,790.00

This IP speaker has a built in microphone for two-way communication.

Part Number: ZT1047

Quantity

California Proposition 65 warning

Description

This combination of an IP phone and IP horn speaker works very well in noisy environments where volume and noise cancellation is needed. Visitors can speak into the horn speaker without any button presses. The operator on the inside phone pushes a button to talk and releases to listen.

This horn speaker features a 10W Class D amplifier, powered over PoE. This means that the speaker is capable of delivering more than 116 dB. The Horn design is ideal for installation in challenging acoustic environments where increased directivity is key to intelligible audio.

You can connect additional horn speakers to the system (see Related Items) and you are able to monitor and address each speaker individually.

The built-in microphone in the horn speaker enables intelligent features such as Automatic Volume Control.

Features:

Horn Speaker:

Crystal clear audio
10W Class D, built-in amplifier
Protected from dust and Water - IP66
116 dB SPL (1m)
Ideal for Micro Zone PA and systems that require a limited number of speakers
Each speaker is individually addressable and monitored
ONVIF Compatible
Ideal for speakers installed in remote locations, e.g. roads and railways
Remote software upgrade and configuration
Relay output for remote control, e.g. doors, signal lamps, gates
Powered from the IP network cable using Power over Ethernet (PoE)
Ideal for Building Security, Infrastructure and Industrial projects
Internal speaker amplifier 10 W class D
Max. sound pressure level at 1 meter 116 dB
Dispersion (-6dB) 1kHz / 4kHz 140° / 40°
Directivity factor, Q 1,8
Codecs G.711, G.722
Frequency range, G.722 Codec 200 Hz – 7000 Hz
Mounting Bracket (included)
Weight 1.8 kg / 4 lbs
Material / Color ASA (plastic) / RAL 7035 (light grey)
Electronics cover material ASA (plastic)
Gasket material Silicone rubber
IP Rating IP66, tested according to EN 60529
ENVIRONMENT AND COMPLIANCES
Operating temperature range -40° to 70° C / -40° to 158 ° F
Storage temperature range -40° to 70° C / -40° to 158 ° F
Relative humidity < 95% not condensing
EMC CE and FCC Part 15
HARDWARE
Ethernet connector 1 x RJ 45
All other connectors Tool less, spring loaded, vibration proof terminals
General inputs and outputs 6 (configurable)
Outputs 12mA as LED drivers
Change-over relay (NO+NC+COM) Max: 250VAC/220VDC, 2A, 60W
Power options PoE
PoE (power over Ethernet) IEEE 802.3af standard, Class 0 (0.44W to 12.95 W)
Power consumption Idle 1.8W, max 12W (depending on volume)
Audio line out / induction loop signal 600 Ohm
NETWORKING AND PROTOCOLS
Protocols IPv4 (with DiffServ), SIP, TCP, UDP, Unicast, Multicast, HTTPS, TFTP, RTP, DHCP, SNMPv2c, ONVIF, CCoIP® , NTP
LAN protocols Power over Ethernet (IEEE 802.3 a-f) Network Access Control (IEEE 802.1x)
Management and operation HTTP/HTTPS (Web configuration) DHCP and static IP + IC-EDGE™. Remote automatic software upgrade. Centralized monitoring
Advanced supervision functions E.g. network test, tone test, status reports
SIP support RFC 3261 (SIP base standard), RFC 3515 (SIP refer), RFC 2976 (SIP info)
DTMF support RFC 2833, 2976 (SIP info)
OTHER SPECIFICATIONS
OTHER SPECIFICATIONS
IP address information Speaks IP address after system boot
Country of manufacture Poland
Dimensions (HxWxD) 144 x 186 x 207 mm
Weight 1.65 kg
Encapsulation material ASA plastic
DIN-rail clips Wago 209 (included)
Boxed Weight 1.8 kg / 4 lbs
Box Dimensions (Width x Height x Depth) 250 x 210 x 170 mm

Phone:

MECHANICAL

Mounting Table top
Dimensions: (W x H x D) 72 x 140 x 270 mm, 2.8 x 5.5 x 10.6 inch
Weight 0.4 kg
Temperature range 0°C - 55°C, 32°C - 131°F
Humidity Non condensing, 10% - 85% RH
Max SPL 85 dB at 1m
Loudspeaker Impedance 8 ohm
Frequency Range 300 - 7000 Hz
Connector 1 x RJ45 (Ethernet) 10/100 Mbps
Direct access display 10 lines, 5-8 characters graphic
Information display 4 lines, 20 characters graphic
Power consumption Power over Ethernet, IEEE 802.3 a-f, Class 0, Idle 4W, max. 8W
IP protocols IP v4 - TCP - UDP - HTTPS – TFTP - RTP - RTCP -DHCP - SNMP - DiffServ - TOS – STENTOFONCCoIP®
LAN protocols Power over Ethernet (IEEE 802.3 a-f), VLAN(IEEE 802.1pq), Network Access Control (IEEE 802.1x), STP (IEEE 802.1d), RSTP (IEEE 802.1d-2004)
Audio technology Wideband 200 Hz - 7 kHz (G.722), Telephony 3.4kHz (G.711), Active noise filtering, Acoustic echo cancellation, Open duplex, Adaptive jitter filter, Handset and volume override
Management and operation HTTPS (Web configuration), DHCP and static IP, Remote automatic software upgrade, Centralized monitoring, Status LED

PoE+ Desktop Switch 4-Port

$60.00

More Info

Intercom Phone Addon 2-button

$492.00

More Info

IP Horn Speaker

$1,295.00

More Info

Intercom with IP Horn Speaker

Related Items

Browse Similar Items