Note that these Chamberlain wireless intercoms have been discontinued and we no longer sell or support them.
After putting batteries in the
intercoms, find the "Learn" button on them. Look at the pictures
below to see where they are on the two available intercom styles.
Clear the memory on all intercoms.
You do that by holding down the Learn button until you hear a beep
and then continue holding until you hear a second beep. Then you let
go of the Learn button.
Set two intercoms side by side.
Press the Learn button on one intercom until you hear a beep
then release it
. Within 10 seconds do the same on the second
intercom. On the indoor intercoms the blue lights on the front will
flash in a scanning pattern. When the scanning quits the programming
is done. The intercom should emit a tone after they are programmed,
but they don't always do this.
Allow about 20 seconds after the
Learn procedure if you have an outdoor style intercom since it does
not have lights to tell you when programming is done.
Now press the Talk button on one
intercom and see if they work. If the volume is turned up, you will
get a squealing noise if the intercoms are close together. This is
normal feedback and it won't occur when the intercoms are separated.
To Program More Than Two Intercoms
After you have cleared the memory on the unit you want to add using the procedure
above, take one of the programmed intercoms and set it next to one
of the additional intercoms you want to program in your network.
Press the Learn button on the new
intercom and release it after you hear a beep.
Within 10 seconds, press the Learn
button on the intercom that is already programmed in your network
and then release it.
Test the intercoms together and they
should now work.