Home > Other Products > Driveway Alarms >

Half-Mile Motion Detector and Receiver Kit
long range Motion Detector kit


 
Item Code: DA1002
Our Price: $189.00
Qty:

Description
 
The DA1002 Half-Mile Motion Detector and Receiver Kit uses a passive infrared (PIR) detector to detect people, vehicles or large animals at the monitored location. When the transmitter detects an object, it sends a signal to the receiver, which will sound one of four different tones (Classical, Westminster Chime, Ding Dong, or Whistle) for a few seconds. The transmitter can be used as a driveway alarm, in the back yard to monitor around tool sheds or patios, or anywhere you need to be alerted of motion.

The receiver part of the DA1002 plugs in to a standard wall outlet and can be placed on a table or mounted on the wall. It has a volume control so you can set the tones to the desired level. The receiver is also equipped with 4 relays (one for each zone) and one 12 volt DC output terminal that can activate when a signal is received (each zone can be set to activate the 12 volt output). The receiver can be user programmed so the 12VDC terminal and relays will activate for 1 second, 10 seconds, 60 seconds or 10 minutes. You can use the relays and DC output to activate lights, sirens, or anything you can think of.

For maximum range between the transmitter and receiver, the receiver should be mounted horizontally on a wall and as high off the floor as possible. Although the maximum range is about 1/2 mile, things such as hills, trees, metal siding and stucco can all reduce the range.

The receiver and transmitter are coded to work together using one of 256 switch combinations so you won't have to worry about interference with neighboring systems.

The DA1002 can have up to four zones with each zone activating a different relay and tone so you'll know which zone has been activated.

The receiver has a red led light for each of the four zones. If you are gone and your system is activated by motion, these lights will tell you something activated your alarm. It even has the capability to flash once for each time the system was activated (for up to ten activations) so you'll not only know the alarm was triggered, but how many times. There is also a reminder beep that can be set to beep every 15 minutes after a signal is received. This beep can be enabled per zone. Buttons on the unit enable you to reset the lights and beep for the next activation.

The receiver can be programmed to have a 5-minute exit delay where it will not receive a signal from selected transmitters. This enable you to exit the premises without setting off the alarm and is programmable per zone.

DA1002
Features
  • Receiver Frequency: 433.92 MHz
  • Receiver Operating voltage: 12VDC
  • Receiver Relay rating: 24VDC at 3 Amp
  • The relays in the receiver are Form C, single-pole, double-throw and break the connection with one throw before making contact with the other (break-before-make)
  • Relays are rated for 24 VDC at 3 Amp maximum current
  • The 12 VDC output has a maximum current capacity of 400mA
  • The transmitter detects people or vehicles to about fifty feet, but occasionally it may detect much farther. For this reason, it is best to avoid pointing the transmitter at streets or roads in the distance.
  • Transmitter Frequency: 433.92 MHz
  • Transmitter Operating range: -30 degree F to 110 degree F
  • Transmitter Battery life: 6-12 months

Related Products and Accessories
Half-Mile Motion Detector Transmitter Half-Mile Motion Detector Receiver
Our Price: $119.97

Add
Our Price: $39.97

Add
Long Range Transmitter Unit Addon Long Range Motion Alert Receiver

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Other Products > Driveway Alarms
Doorbell Devices
Other Products > Access Control Systems
Other Products