The Handsfree Door Intercom is a speaker phone designed to provide two-way handsfree communication to the Door Intercom Controller with Call Forwarding. When the "Call" button is pressed, this intercom comes off-hook and the controller routes the call as programmed. This unit is designed with enhanced weather protection so it can be in direct rain.
Applications:
Compact size: Front panel is the size of a typical single gang mid- size wall plate
Mounting: Flush mounts in any single gang (1.7in. deep minimum) electrical box
Vandal Resistant Features: 16 gauge polished brass or 18 gauge stainless steel faceplate, stainless steel push button, stainless steel speaker screen, scratch resistant powder coating, hex drive mounting screws
Telephone line powered
Microphone and speaker volume controls
Programmable Intelligent call progress detection for automatic hang-up on CPC, silence, busy signal, or time out
Selectable auto answer feature for monitoring
Programmable VOX (mic/speaker) switching speed
Rubber gaskets and boots, closed cell foam gasketing, hand soldered silicon sealed connections, anti-corrosive gel filled tip and ring connectors, urethane encapsulated circuit boards with internally sealed, field-adjustable trim POTS and DIP switches.
Power: Telephone line powered (18 VDC/20mA minimum)
Dimensions: Faceplate: 123.8mm x 79.4mm x 4.6mm (4.875 in. x 3.125 in. x 0.18 in.), Rough-in box (Allied Molded 9331): 86.4mm x 61mm x 63.5mm (3.4 in. x 2.4 in. x 2.5 in.)
Operating Temperature: -32 DC. to 54 DC. (-25 DF. to 130 DF.)
Humidity: Standard model: 5% to 95% non-condensing humidity, EWP model: up to 100% humidity
Speaker Volume: Approximately 62db maximum at 1m
Ring Voltage: 25V AC RMS minimum (for auto answer)
CPC Disconnect Time: 300ms minimum
REN: 0.8A
Copyright IntercomsOnline.com. All Rights Reserved.
