Q:I have a Beninca BULL5M sliding gate motor. Is this product compatible with it?
Asked by: Chuck
- 11/25/2020
A: This product will work with any gate opener. You just run two wires from the intercom to the gate opener and when you press a button on the intercom app, it closes a switch to activate the gate.
Was this answer helpful?
0 of 0 Customer(s) found this Answer helpful.
Q:Our gated community has a land line phone system connected to our key pad by via cable underneath. Can we get gate to work by wireless system? Thanks
Asked by: Bruce
- 5/20/2021
A: This product is a single family unit and will not work to call all the homes in a gated community. The only wireless units we have for multi-family are cellular based. These require cell service at the gate and the intercom calls any phone number programmed into it for each tenant. This system has no video. There is also one that requires a CAT-5 cable with Internet that can provide video: https://www.intercomsonline.com/touch-screen-internet-connected-video-intercom
Was this answer helpful?
0 of 0 Customer(s) found this Answer helpful.
A: Yes it works with all gate openers. All it does is close a switch which activates the gate. You just run two wires from the switch to the gate controller.
Was this answer helpful?
0 of 0 Customer(s) found this Answer helpful.
Q:Are remote key FOBs available to open/close gate?
Asked by: Mike
- 10/27/2021
A: No but you can easily add one using low cost products like this: https://www.intercomsonline.com/wireless-remote-control-gate-opener available on Amazon.
Was this answer helpful?
0 of 0 Customer(s) found this Answer helpful.
Q:Our gate opens through key fabs. Running a wire to the gate motor is not really an option. Can the system be trained to the key fab channel?
Asked by: Juergen
- 12/15/2021
A: No there is no way of doing that. If you can't have someone install a conduit under the driveway there are wireless devices that can send a wireless signal across the driveway. You would put one board inside the intercom and the other inside the gate controller. https://store.ncd.io/product/wireless-contact-closure-transmitter-receiver-1-channel-spdt-relay-2-way-2/
Was this answer helpful?
0 of 0 Customer(s) found this Answer helpful.
Q:Your wi fi video system with keypad ..part number IO1039…is it totally wireless…or does it require some wires running ..wherever .
Asked by: Pauline
- 1/6/2022
A: It needs wires to a power supply plugged in to an outlet or to a solar panel system. Also, if you want it to open a gate, then it needs two wires run to your gate opener system. The system can use Wi-Fi wireless back to the house or business.
Was this answer helpful?
0 of 0 Customer(s) found this Answer helpful.
Q:I would like to control access to a driveway gate and also a pedestrian gate. I would like a keypad for each location (one for the driveway gate and one for the pedestrian gate) Can one master controller be used for both functions? Can I just add a separate keypad if this is possible?